Using The Embedded Hypervisor - Lenovo x3550 M4 Installation And Service Manual

7. Exit from the Setup utility.
Logging on to the web interface
Use this information to log on to the web interface.
About this task
To log on to the IMM web interface, complete the following steps:
Procedure
1. On a system that is connected to the server, open a web browser. In the
2. On the Login page, type the user name and password. If you are using the
3. Click Log in to start the session. The System Status and Health page provides a
Results
Note: If you boot to the operating system while in the IMM GUI and the message
Booting OS or in unsupported OS is displayed under System Status > System
State, disable Windows 2008 or 2012 firewall or type the following command in
the Windows 2008 or 2012 console. This might also affect blue-screen capture
features.
By default, the icmp packet is blocked by Windows firewall. The IMM GUI will
then change to "OS booted" status after you change the setting as indicated above
in both the Web and CLI interfaces.

Using the embedded hypervisor

The VMware ESXi embedded hypervisor software is available on the optional IBM
USB flash device with embedded hypervisor.
About this task
The USB flash device can be installed in USB connectors on the system board (see
"System-board internal connectors" on page 28 for the location of the connectors).
Hypervisor is virtualization software that enables multiple operating systems to
run on a host system at the same time. The USB flash device is required to activate
the hypervisor functions.
112
System x3550 M4 Type 7914: Installation and Service Guide
Address or URL field, type the IP address or host name of the IMM to which
you want to connect.
Note: If you are logging on to the IMM for the first time after installation, the
IMM defaults to DHCP. If a DHCP host is not available, the IMM assigns a
static IP address of 192.168.70.125. The IMM network access tag provides the
default host name of the IMM and does not require you to start the server.
IMM for the first time, you can obtain the user name and password from your
system administrator. All login attempts are documented in the system-event
log.
Note: The IMM is set initially with a user name of USERID and password of
PASSW0RD (with a zero, not a the letter O). You have read/write access. You
must change the default password the first time you log on.
quick view of the system status.
netsh firewall set icmpsetting type=8 mode=ENABLE