4: Printer Options; Overview; Installing The Network Interface Card (Nic); First, Prepare The Printer - NEC Super Script 4400 Maintenance Manual

CHAPTER 4
PRINTER OPTIONS
O
VERVIEW
This chapter provides instructions for installing and using printer options, including
•

Installing the Network Interface Card (NIC)

• Installing the Legal Paper Tray
• Adding the Paper Tray 2 Unit
• Adding Memory (SIMM)
I
NSTALLING THE
Part # 4010
If you have the SuperScript 4400N printer it is already equipped with a Network Interface Card (NIC). If you
purchased the NEC SuperScript 4400, you can upgrade it by installing a network interface card (NIC). Use the
directions in this section for installation
.

First, Prepare the Printer

1. Turn off the printer, remove the power cord from the rear panel of the printer, and disconnect the printer cable
from the port (A). Position the printer so you are facing the side and back corner where the cable port is
located. Make sure that you have enough room to work.
2. Using a small phillips-head screw driver remove the two screws from the expansion slot on the rear of the
printer (B), and pull out the Controller Board.
N I
ETWORK NTERFACE
SuperScript 4400 Network Interface Card
C (NIC)
ARD
53