Table of Contents
Advertisement
Second, Install the NIC
These steps are illustrated on the opposite page.
1.
Remove the NIC from its protective bag (A).
2.
Remove the mounting screw from the end of the standoff pin on the controller board (B).
3.
Hold the NIC so that its circuitry faces inside the printer and its LED's face the back of the printer. Carefully
align the standoff pin with the lower right corner of the NIC.
4.
Plug the NIC's connector to the Controller Board as shown (C).
5.
Use the mounting screw removed in step 5 to fasten the lower right corner of the NIC to the standoff pin.
Attach the screw removed from the front in step 3 (D).
6.
Slide the Controller Board back in the expansion slot. Reinstall and tighten the screws (E).
Installing the NIC
A
C
D
B
E
Installing the Network Interface Card (NIC)
55
Advertisement
Chapters
Table of Contents
