AudioCodes Mediant 600 User Manual page 388

Parameter
Web: FXO AutoDial Play
BusyTone
[FXOAutoDialPlayBusyTone]
Web: Hotline Dial Tone
Duration
EMS: Hot Line Tone Duration
[HotLineToneDuration]
Web: Time Before Reorder
Tone [sec]
[TimeBeforeReorderTone]
Web/EMS: Reorder Tone
Duration [sec]
[TimeForReorderTone]
Web: Enable Comfort Tone
[EnableComfortTone]
[WarningToneDuration]
SIP User's Manual
Determines whether the device plays a Busy/Reorder tone to the
PSTN side if a Tel-to-IP call is rejected by a SIP error response
(4xx, 5xx or 6xx). If a SIP error response is received, the device
seizes the line (off-hook), and then plays a Busy/Reorder tone to
the PSTN side (for the duration defined by the parameter
TimeForReorderTone). After playing the tone, the line is released
(on-hook).
[0] = Disable (default)
[1] = Enable
Note: This parameter is applicable only to FXO interfaces.
Duration (in seconds) of the Hotline dial tone. If no digits are
received during this duration, the device initiates a call to a user-
defined number (refer to "Automatic Dialing" on page 167).
The valid range is 0 to 60. The default is 16.
Note: This parameter is applicable to FXS and FXO interfaces.
The delay interval (in seconds) from when the device receives a
SIP BYE message (i.e., remote party terminates call) until the
device starts playing a reorder tone to the FXS phone.
The valid range is 0 to 60. The default is 0.
Note: This parameter is applicable only to FXS interfaces.
For Analog: The duration (in seconds) that the device plays a Busy
or Reorder tone duration before releasing the line.
The valid range is 0 to 254. The default is 0 seconds.
Typically, after playing a Reorder / Busy tone for the specified
duration, the device starts playing an Offhook Warning tone.
For Digital: The duration (in seconds) that the CAS device plays a
Busy or Reorder Tone before releasing the line.
The valid range is 0 to 254. The default value is 10.
This parameter is also applicable for ISDN when
PlayBusyTone2ISDN is set to 2.
Notes:
The selection of Busy or Reorder tone is performed according to
the release cause received from IP.
Refer also to the parameter CutThrough.
Determines whether the device plays a Comfort Tone (Tone Type
#18) to the FXS/FXO endpoint after a SIP INVITE is sent and
before a SIP 18x response is received.
[0] = Disable (default)
[1] = Enable
Note: This parameter is applicable only to FXO/FXS interfaces.
Defines the duration (in seconds) for which Off-Hook Warning Tone
is played to the user.
The valid range is -1 to 2,147,483,647. The default is 600.
Notes:
A negative value indicates that the tone is played infinitely.
This parameter is applicable only to analog interfaces.
388
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83305