AudioCodes Mediant 600 User Manual page 354

Parameter
Web/EMS: Clock Master
[ClockMaster]
[ClockMaster_x]
Web/EMS: Line Code
[LineCode]
[LineCode_x]
[TrunkLifeLineType]
[TrunkAdministrativeState]
Web/EMS: Line Build Out Loss
[LineBuildOut.Loss]
SIP User's Manual
Determines the Tx clock source of the E1/T1 line.
[0] Recovered = Generate the clock according to the Rx of the
E1/T1 line (default).
[1] Generated = Generate the clock according to the internal
TDM bus.
Notes:
The source of the internal TDM bus clock is determined by the
parameter TDMBusClockSource.
For detailed information on configuring the device's clock
settings, refer to Clock Settings on page 561.
Same as the description for parameter ClockMaster, but for a
specific Trunk ID (where x denotes the Trunk ID and 0 is the first
Trunk).
Selects B8ZS or AMI for T1 spans, and HDB3 or AMI for E1 spans.
[0] B8ZS = use B8ZS line code (for T1 trunks only) default.
[1] AMI = use AMI line code.
[2] HDB3 = use HDB3 line code (for E1 trunks only).
Note: This parameter is not configurable for BRI interfaces; the
device automatically uses the Modified Alternate Mark Invert
(MAMI) line code.
Same as the description for parameter LineCode, but for a specific
trunk ID (where 0 depicts the first trunk).
Defines the type of trunk Lifeline. Short trunks 1-2, 3-4.
[0] = Activate Lifeline on power down (default).
[1] = Activate Lifeline on power down or on detection of LAN
disconnection.
[2] = Activate Lifeline on power down or on detection of LAN
disconnection or loss of ping.
Note: For this parameter to take effect, a device reset is required.
Defines the administrative state of a trunk.
[0] = Lock the trunk; stops trunk traffic to configure the trunk
protocol type.
[2] = Unlock the trunk (default); enables trunk traffic.
Defines the line build out loss for the selected T1 trunk.
[0] 0 dB (default)
[1] -7.5 dB
[2] -15 dB
[3] -22.5 dB
Note: This parameter is not applicable for PRI E1 and BRI trunks.
354
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83305