Viewing Call Routing Status; Table 3-40: Call Routing Status Parameters - AudioCodes Mediant 600 User Manual

Counter
Number of Failed Calls
due to No Matched
Capabilities
Number of Failed Calls
due to No Resources
Number of Failed Calls
due to Other Failures
Average Call Duration
(ACD) [sec]
Attempted Fax Calls
Counter
Successful Fax Calls
Counter
3.5.2.2

Viewing Call Routing Status

The 'Call Routing Status' page provides you with information on the current routing method
used by the device. This information includes the IP address and FQDN (if used) of the
Proxy server with which the device currently operates.
To view the call routing status:
Open the 'Call Routing Status' page (Status & Diagnostics tab > Gateway Statistics
menu > Calls Routing Status page item).
Parameter
Current Call-Routing
Method
SIP User's Manual
Indicates the number of calls that failed due to mismatched device
capabilities. It is incremented as a result of an internal identification of
capability mismatch. This mismatch is reflected to CDR via the value of
the parameter DefaultReleaseReason (default is
GWAPP_NO_ROUTE_TO_DESTINATION (3)) or by the
GWAPP_SERVICE_NOT_IMPLEMENTED_UNSPECIFIED (79) reason.
Indicates the number of calls that failed due to unavailable resources or
a device lock. The counter is incremented as a result of one of the
following release reasons:
GWAPP_RESOURCE_UNAVAILABLE_UNSPECIFIED
RELEASE_BECAUSE_GW_LOCKED
This counter is incremented as a result of calls that failed due to reasons
not covered by the other counters.
The average call duration (ACD) in seconds of established calls. The
ACD value is refreshed every 15 minutes and therefore, this value
reflects the average duration of all established calls made within a 15
minute period.
Indicates the number of attempted fax calls.
Indicates the number of successful fax calls.
Figure 3-134: Call Routing Status Page

Table 3-40: Call Routing Status Parameters

Proxy = Proxy server is used to route calls.
Routing Table preferred to Proxy = The 'Tel to IP Routing' table takes
precedence over a Proxy for routing calls ('Prefer Routing Table'
parameter is set to 'Yes' as described in ''Configuring Proxy and
Registration Parameters'' on page 108).
212
Mediant 600 & Mediant 1000
Description
Description
Document #: LTRT-83305