Metering Tone Parameters - AudioCodes Mediant 600 User Manual

Parameter

6.14.3 Metering Tone Parameters

The metering tone parameters are described in the table below.
Parameter
Web: Generate Metering
Tones
EMS: Metering Mode
[PayPhoneMeteringMode]
Web: Metering Tone Type
EMS: Metering Type
[MeteringType]
Web: Charge Codes Table
EMS: Telephony FXS And FXO (SIP) Parameters Provisioning > Charge Codes
[ChargeCode]
SIP User's Manual
INFO message containing a hook-flash signal.
FXO interfaces: Hook-flash generation period.
Notes:
For FXO interfaces, a constant of 100 msec must be
added to the required hook-flash period. For example, to
generate a 450 msec hook-flash, set this parameter to
550.
For this parameter to take effect, you need to reset the
device.
Table 6-55: Metering Tone Parameters
Determines the method used to configure the metering tones that are
generated to the Tel side.
[0] Disable = Metering tones aren't generated (default).
[1] Internal Table = Metering tones are generated according to the
internal table configured by the parameter ChargeCode.
Notes:
This parameter is applicable only to FXS interfaces.
If you select 'Internal Table', you must configure the 'Charge Codes
Table' (refer to ''Configuring the Charge Codes Table'' on page
132).
Defines the metering tone (12 or 16 kHz) that is generated by FXS
interfaces.
[0] 12 kHz = 12-kHz metering tone (default).
[1] 16 kHz = 16-kHz metering tone.
Notes:
A suitable (12 or 16 KHz) FXS Coefficient file must be used for FXS
interfaces.
For this parameter to take effect, a device reset is required.
This ini file table parameter configures metering tones (and their time
intervals) that the device's FXS interface generates to the Tel side.
The format of this parameter is as follows:
[ChargeCode]
FORMAT ChargeCode_Index = ChargeCode_EndTime1,
ChargeCode_PulseInterval1, ChargeCode_PulsesOnAnswer1,
ChargeCode_EndTime2, ChargeCode_PulseInterval2,
ChargeCode_PulsesOnAnswer2, ChargeCode_EndTime3,
ChargeCode_PulseInterval3, ChargeCode_PulsesOnAnswer3,
ChargeCode_EndTime4, ChargeCode_PulseInterval4,
394
Mediant 600 & Mediant 1000
Description
Description
Document #: LTRT-83305