Software Upgrade Wizard - AudioCodes Mediant 600 User Manual

3.4.2.2.1 Loading via BootP/TFTP
The procedure below describes how to load a Software Upgrade Key to the device using
AudioCodes' BootP/TFTP Server utility (for a detailed description on the BootP utility, refer
to the Product Reference Manual).
To load a Software Upgrade Key file using BootP/TFTP:
1. Place the Software Upgrade Key file (typically, a *.txt file) in the same folder in which
the device's cmp file is located.
2. Start the BootP/TFTP Server utility.
3. From the Services menu, choose Clients; the 'Client Configuration' screen is
displayed.
4. From the 'INI File' drop-down list, select the Software Upgrade Key file. Note that the
device's cmp file must be specified in the 'Boot File' field.
5. Configure the initial BootP/TFTP parameters as required, and then click OK.
6. Reset the device; the cmp and Software Upgrade Key files are loaded to the device.
Note:
3.4.2.3

Software Upgrade Wizard

The Software Upgrade Wizard allows you to upgrade the device's firmware (cmp file) as
well as load an ini file and/or auxiliary files (e.g., Call Progress Tones). However, it is
mandatory, when using the wizard to first load a cmp file to the device. You can then
choose to also load an ini file and/or auxiliary files, but this cannot be pursued without first
loading a cmp file. For the ini and each auxiliary file type, you can choose to load a new file,
or not load a file but use the existing file (i.e., maintain existing configuration) running on the
device.
The Software Upgrade Wizard allows you to load the following files:
cmp: (Mandatory) compressed firmware file
Optional files:
•
ini: configuration file
•
Auxiliary files: CPT (Call Progress Tone), VP (Voice Prompts), PRT
(Prerecorded Tones), CAS, FXS Coefficient, and USERINF (User Information)
SIP User's Manual
To load the Software Upgrade Key using BootP/TFTP, the extension name of
the key file must be *.ini.
200
Mediant 600 & Mediant 1000
Document #: LTRT-83305