AudioCodes Mediant 600 User Manual page 171

SIP User's Manual
Parameter
Forward to Phone
Number
Time for No Reply
Forward
3.3.5.10.5 Configuring Caller ID Permissions
The 'Caller ID Permissions' page allows you to enable or disable (per port) the Caller ID
generation (for FXS interfaces) and detection (for FXO interfaces). If a port isn't configured,
its Caller ID generation/detection are determined according to the global parameter
EnableCallerID described in ''Configuring Supplementary Services'' on page 131.
Note:
To configure Caller ID Permissions per port:
1. Open the 'Caller ID Permissions' page (Configuration tab > Protocol Configuration
menu > Endpoint Settings submenu > Caller ID Permissions page item).
2. From the 'Caller ID' drop-down list, select one of the following:
•
'Enable': Enables Caller ID generation (FXS) or detection (FXO) for the specific
port.
•
'Disable': Caller ID generation (FXS) or detection (FXO) for the specific port is
disabled.
•
Not defined: Caller ID generation (FXS) or detection (FXO) for the specific port is
determined according to the parameter 'Enable Caller ID' (described in
''Configuring Supplementary Services'' on page 131).
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 193.
Version 5.8
The telephone number or URI (<number>@<IP address>) to where the
call is forwarded.
Note: If this field only contains a telephone number and a Proxy isn't
used, the 'forward to' phone number must be specified in the 'Tel to IP
Routing' table (refer to ''Configuring the Tel to IP Routing Table'' on page
148).
If you have set the 'Forward Type' for this port to 'No Answer', enter the
number of seconds the device waits before forwarding the call to the
phone number specified.
You can also configure the Caller ID Permissions table using the ini file table
parameter EnableCallerID.
Figure 3-101: Caller ID Permissions Page
Description
171
3. Web-Based Management
September 2009