AudioCodes Mediant 600 User Manual page 377

SIP User's Manual
Parameter
[ISDNDMSTimerT310]
[ISDNJapanNTTTimerT3JA]
[Enable911LocationIdIP2Tel]
[EarlyAnswerTimeout]
Web: Trunk Transfer Mode
[TrunkTransferMode]
Version 5.8
interworking: SIP INVITE to SETUP, SIP 200 OK to
CONNECT, SIP INFO to USER INFORMATION, SIP 18x to
ALERT, and SIP BYE to DISCONNECT.
Notes:
The interworking of User-to-User IE to SIP INFO is
supported only on the 4ESS PRI variant.
To interwork the UUIE header from SIP-to-ISDN messages
with the 4ESS ISDN variant, the parameter
ISDNGeneralCCBehavior must be set to 16384.
Overrides the T310 timer for the DMS-100 ISDN variant.
T310 defines the timeout between the receipt of a Proceeding
message and the receipt of an Alerting/Connect message.
The valid range is 10 to 30. The default value is 10 (seconds).
Note: Applicable only to Nortel DMS and Nortel MERIDIAN
PRI variants (ProtocolType = 14 and 35).
T3_JA timer (in seconds). This parameter overrides the
internal PSTN T301 timeout on the Users Side (TE side).
If an outgoing call from the device to ISDN is not answered
during this timeout, the call is released.
The valid range is 10 to 240. The default value is 50.
Applicable only to Japan NTT PRI variant (ProtocolType = 16).
Note: This timer is also affected by the parameter
PSTNAlertTimeout.
Enables interworking of Emergency Location Identification
from SIP to PRI.
[0] = Disabled (default)
[1] = Enabled
When enabled, the From header received in the SIP INVITE is
translated into the following ISDN Information Elements (IE):
Emergency Call Control IE.
Generic Information IE to carry the Location Identification
Number information.
Generic Information IE to carry the Calling Geodetic
Location information.
Note: This capability is supported only for the NI-2 ISDN
variant.
Defines the time (in seconds) that the device waits for a
CONNECT message from the called party (Tel side) after
sending a SETUP message. If the timer expires, the call is
answered by sending a 200 OK message (IP side).
The valid range is 0 to 600. The default value is 0 (i.e.,
disabled).
Enables the trunk transfer mode.
377
6. Configuration Parameters Reference
Description
September 2009