AudioCodes Mediant 600 User Manual page 120

Parameter
Serving IP Group
[Account_ServingIPGroup]
Username
[Account_Username]
Password
[Account_Password]
Host Name
[Account_HostName]
SIP User's Manual
The destination IP Group ID (defined in ''Configuring the IP
Groups'' on page 114) to where the REGISTER requests (if
enabled) are sent or Authentication is performed. The actual
destination to where the REGISTER requests are sent is the IP
address defined for the Proxy Set ID (refer to ''Configuring the
Proxy Sets Table'' on page 110) associated with this IP Group.
This occurs only in the following conditions:
The parameter 'Registration Mode' is set to 'Per Account' in the
'Trunk Group Settings' table (refer to ''Configuring the Trunk
Group Settings'' on page 175).
The parameter 'Register' in this table is set to 1.
In addition, for a SIP call that is identified by both the Served
Trunk Group/ Served IP Group and Serving IP Group, the
username and password for digest authentication defined in this
table is used.
For Tel-to-IP calls, the Serving IP Group is the destination IP
Group defined in the 'Trunk Group Settings' table or 'Tel to IP
Routing' table (refer to ''Configuring the Tel to IP Routing Table''
on page 148). For IP-to-Tel calls, the Serving IP Group is the
'Source IP Group ID' defined in the 'IP to Trunk Group Routing'
table (refer to ''Configuring the IP to Trunk Group Routing'' on
page 156).
Note: If no match is found in this table for incoming or outgoing
calls, the username and password defined in the 'Authentication'
table for FXS interfaces (refer to "Configuring Authentication" on
page 166) or the global parameters (UserName and Password)
defined on the 'Proxy & Registration' page.
Digest MD5 Authentication user name (up to 50 characters).
Digest MD5 Authentication password (up to 50 characters).
Defines the Address of Record (AOR) host name. It appears in
REGISTER From/To headers as ContactUser@HostName. For
successful registrations, this HostName is also included in the
INVITE request's From header URI. If not configured or if
registration fails, the 'SIP Group Name' parameter from the 'IP
Group' table is used instead.
This parameter can be up to 49 characters.
120
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83305