AudioCodes Mediant 600 User Manual page 313

SIP User's Manual
Parameter
Version 5.8
IPProfile_SigIPDiffServ*, IpProfile_SCE,
IPProfile_RTPRedundancyDepth, IPProfile_RemoteBaseUDPPort,
IPProfile_CNGmode, IPProfile_VxxTransportType,
IPProfile_NSEMode, IpProfile_IsDTMFUsed,
IPProfile_PlayRBTone2IP, IPProfile_EnableEarlyMedia*,
IPProfile_ProgressIndicator2IP*, IPProfile_EnableEchoCanceller*,
IPProfile_CopyDest2RedirectNumber,
IPProfile_MediaSecurityBehaviour, IPProfile_CallLimit, IPProfile_
DisconnectOnBrokenConnection, IPProfile_FirstTxDtmfOption,
IPProfile_SecondTxDtmfOption, IPProfile_RxDTMFOption,
IpProfile_EnableHold, IpProfile_InputGain, IpProfile_VoiceVolume,
IpProfile_AddIEInSetup, IpProfile_SBCExtensionCodersGroupID,
IPProfile_MediaIPVersionPreference, IPProfile_TranscodingMode;
[\IPProfile]
For example:
IPProfile 0 = Sevilia, 1, 1, 0, 10, 10, 46, 40, 0, 0, 0, 0, 2, 0, 0, 0, 0, -1, 1,
0, 0, -1, 1, -1, -1, 1, 1, 0, 0, , -1, 4294967295, 0;
Notes:
You can configure up to nine IP Profiles (i.e., indices 1 through 9).
The parameters SBCExtensionCodersGroupID and
TranscodingMode are not applicable.
The parameter MediaIPVersionPreference is not applicable.
The parameter IsDTMFUsed is not applicable.
Parameters common to both IP and Tel profiles are indicated by an
asterisk (*).
The parameter IpPreference determines the priority of the IP Profile
(1 to 20, where 20 is the highest preference). If both IP and Tel
profiles apply to the same call, the coders and other common
parameters (indicated with an asterisk) of the preferred Profile are
applied to that call. If the Tel and IP profiles are identical, the Tel
Profile parameters take precedence.
To assign the parameter's default value, enter two dollar signs ('$$').
To use the settings of the corresponding global parameter, enter the
value -1.
IP Profiles can be used in the 'Tel to IP Routing' (or 'Outbound IP
Routing Table' if IP-to-IP application is enabled) and 'IP to Trunk
Group Routing' tables (Prefix and PSTNPrefix parameters).
Configure intuitive names (ProfileName) for the IP Profiles so that
they can later be easily identified.
The parameter CallLimit defines the maximum number of concurrent
calls allowed for that Profile. If the Profile is set to some limit, the
device maintains the number of concurrent calls (incoming and
outgoing) pertaining to the specific Profile. A limit value of [-1]
indicates that there is no limitation on calls (default). A limit value of
[0] indicates that all calls are rejected. When the number of
concurrent calls is equal to the limit, the device rejects any new
incoming and outgoing calls pertaining to that profile.
RxDTMFOption configures the received DTMF negotiation method: [-
1] not configured, use the global parameter; [0] don't declare RFC
2833; [1] declare RFC 2833 payload type is SDP.
FirstTxDtmfOption and SecondTxDtmfOption configures the transmit
313
6. Configuration Parameters Reference
Description
September 2009