Fxo Gateway Configuration - AudioCodes Mediant 600 User Manual

9.25.6 FXO Gateway Configuration

The procedure below describes how to configure the FXO interface (to which the PBX is
directly connected).
To configure the FXO interface:
1. In the 'Trunk Group Table' page (refer to "Configuring the Trunk Group Table" on page
173, assign the phone numbers 200 to 204 to the device's FXO endpoints.
Figure 9-32: Assigning Phone Numbers to FXO Ports
2. In the 'Automatic Dialing' page, enter the phone numbers of the FXS device in the
'Destination Phone Number' fields. When a ringing signal is detected at Port #1, the
FXO device automatically dials the number '100'.
3. In the 'Tel to IP Routing' page, enter 10 in the 'Destination Phone Prefix' field, and the
IP address of the FXS device (10.1.10.3) in the field 'IP Address'.
4. In the 'FXO Settings' page (refer to ''Configuring the FXO Parameters'' on page 182),
set the parameter 'Dialing Mode' to 'Two Stages' (IsTwoStageDial = 1).
SIP User's Manual
Figure 9-33: FXO Automatic Dialing Configuration
Figure 9-34: FXO Tel-to-IP Routing Configuration
536
Mediant 600 & Mediant 1000
Document #: LTRT-83305