Installing The Hdmx Module - AudioCodes Mediant 600 User Manual

SIP User's Manual
3. Insert the iPMX module into the first slot, closest to the power connection, as shown in
the figure below.
4. Push the iPMX module into the slot and press on it firmly to ensure it has been fully
inserted.
5. Using a flathead screwdriver, tighten the module's two captive mounting screws
located on the bottom right and left corners.
6. Using a Philips screwdriver, tighten the module's two Philips screws located on the top
right and left corners.

14.1.4 Installing the HDMX Module

The Hard Drive module (HDMX) is installed on the rear panel of the device, as described in
the following procedure:
To install the HDMX module:
1. Place the device so that the rear panel is facing you.
2. Remove the black metal cover plates in the first and second slots located on the right
side of the power connection.
3. Use the cutter tool to remove the small metal strip between the upper and lower slots.
Version 5.8
Figure 14-7: Inserting iPMX Module
645
14. Open Solution Network (OSN) Server
September 2009