AudioCodes Mediant 600 User Manual page 440

Parameter
Web: Max Digits in Phone
Num
EMS: Max Digits in Phone
Number
[MaxDigits]
Web: Inter Digit Timeout for
Overlap Dialing [sec]
EMS: Interdigit Timeout (Sec)
[TimeBetweenDigits]
SIP User's Manual
An example of a digit map is shown below:
11xS|00T|[1-7]xxx|8xxxxxxx|#xxxxxxx|*xx|91xxxxxxxxxx|9011x.T
In the example above, the last rule can apply to International
numbers - 9 for dialing tone, 011 Country Code, and then any
number of digits for the local number ('x.').
Notes:
For this parameter to take effect, a device reset is required.
For BRI/PRI interfaces, the digitmap mechanism is applicable
only when ISDN Overlap dialing is used (ISDNRxOverlap is set
to 1).
If the parameter DialPlanIndex is configured (to select a dial
plan index), then the parameter DigitMapping is ignored.
For a detailed description of the digit mapping, refer to ''Digit
Mapping'' on page 461.
Defines the maximum number of collected destination number
digits that can be received (i.e., dialed) from the Tel side (analog)
when Tel-to-IP ISDN overlap dialing is performed (digital). When
the number of collected digits reaches the maximum, the device
uses these digits for the called destination number.
The valid range is 1 to 49. The default value is 5 for analog and 30
for digital.
Notes:
Digit Mapping Rules can be used instead.
Dialing ends when any of the following scenarios occur:
Maximum number of digits is dialed
Interdigit Timeout (TimeBetweenDigits) expires
Pound (#) key is pressed
Digit map pattern is matched
Defines the time (in seconds) that the device waits between digits
that are dialed by the calling party for Tel-to-IP calls are received
from the Tel side when Tel-to-IP overlap dialing is performed (ISDN
uses overlap dialing). When this inter-digit timeout expires, the
device uses the collected digits to dial the called destination
number.
The valid range is 1 to 10. The default value is 4.
440
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83305