Stored Programming (Calling A Stored Program For Build Job) - Xerox ApeosPort-III C7600 User Manual

[Delete Outside/Delete Inside - Area 1 (Area 2 or Area 3)] Screen
Set the area to be deleted. The area is defined by the rectangle formed between the
points X1,Y1 and X2,Y2. The origin point is the top-right corner of a document.
You can specify a value within the range of 0 to 432 mm for the width (X) and the length
(Y) in 1 mm increments.
Note • Specify the 2 coordinates from the top right corner of the document.
• When specifying multiple areas, the specified areas can overlap each other.
• When [Reduce/Enlarge] is enabled, the specified area will be reduced/enlarged accordingly.
1
Select [Area 1], [Area 2], or [Area 3].
2
Enter the value for X1 into [X1] using the
numeric keypad, and select [Save].
3
Enter the value for Y1 into [Y1] using the
numeric keypad, and select [Save].
4
Enter the value for X2 into [X2] using the
numeric keypad, and select [Save].
5
Enter the value for Y2 into [Y2] using the
numeric keypad, and select [Save].
Note • If all of [X1], [Y1], [X2], and [Y2] are set to [0], the area will be invalid. If no other area is
• If you select <C> button, the value is cleared.
Clear Area 1 (Area 2 or Area 3)
Clears all the values set for Area 1 (Area 2 or Area 3).

Stored Programming (Calling a Stored Program for Build Job)

This feature allows you to call a stored program for build job.
For information on this feature, refer to "Calling a Stored Program for Build Job" (P.295).
specified, the Delete Outside/Delete Inside feature cannot be used.
Job Assembly
3
135