Show Dot1Q-Tunnel - Edge-Core ECS4510-28P User Manual

R
show interfaces switchport (984)
This command displays information about QinQ tunnel ports.

show dot1q-tunnel

S
C
Privileged Exec
E
R
switchport dot1q-tunnel mode
C
ELATED OMMANDS
YNTAX
show dot1q-tunnel [interface interface [service svid] |
service [svid]]
interface
ethernet unit/port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
svid - VLAN ID for the outer VLAN tag (SPVID). (Range: 1-4093)
M
OMMAND ODE
XAMPLE
Console(config)#dot1q-tunnel system-tunnel-control
Console(config)#interface ethernet 1/1
Console(config-if)#switchport dot1q-tunnel mode access
Console(config-if)#interface ethernet 1/2
Console(config-if)#switchport dot1q-tunnel mode uplink
Console(config-if)#end
Console#show dot1q-tunnel
802.1Q Tunnel Status : Enabled
Port Mode TPID (hex)
-------- ------ ----------
Eth 1/ 1 Access 8100
Eth 1/ 2 Uplink 8100
Eth 1/ 3 Normal 8100
. .
.
Console#show dot1q-tunnel interface ethernet 1/5
802.1Q Tunnel Service Subscriptions
Port Match C-VID S-VID
-------- ----------- -----
Eth 1/ 5 1
Console#show dot1q-tunnel service 100
802.1Q Tunnel Service Subscriptions
Port Match C-VID S-VID
-------- ----------- -----
Eth 1/ 5 1
Eth 1/ 6 1
Console#
C
ELATED OMMANDS
– 1139 –
C
HAPTER
Configuring IEEE 802.1Q Tunneling
100
100
100
(1135)
| VLAN Commands
40