Bottom Plate; Rear Plate - Intermec EasyCoder 501 XP Service Manual

4.3 Bottom Plate

4.4 Rear Plate

Intermec EasyCoder 501 XP – Service Manual Ed. 4
The bottom plate is fi tted with four easily replaceable rubber feet.
These feet could be removed and the holes used to bolt the printer
to a frame, table or similar. The holes have a diameter of 10 mm
(0.39 inches).
The two keyholes should never be used to bolt the printer to a
frame, or the bottom plate may be bent causing ribbon wrinkling
and media misalignment. These holes are only used for fi xtures
during manufacture.
The bottom plate is also fi tted with four hinges, two for the front
hatch or cutter unit and the other two for the right-hand door. In
case of misalignment, the hinges could be adjusted using a #T10
Torx key.
The rear plate is attached to the bottom plate using three #T20 Torx
screws and to the center section by two #T20 Torx screws. There
is also a bracket between the rear plate and the center section. The
rear plate has a number of slots for connectors, switches etc. as
illustrated below.
Chapter 4 Chassis
Provision for one Optional Interface Board
Bar Code Wand Connector
On/Off Switch
Provision for 1 – 2 Electronic Keys
AC Power Cord Receptacle
RS-232 Serial Interface ("uart1:")
Upper External Media Intake
Centronics Parallel Interface
Memory Card Slot
Lower External Media Intake
23