Easycoder 501 Xp: Setup Mode Overview, Part 3 - Intermec EasyCoder 501 XP Service Manual

Setup Mode Overview, Part 3 (FP 7.40)
If an optional Double Serial or Industrial Interface Board is fitted, additional menus will be displayed
(in case of Double Serial Interface Board, also see Overview Part 4):
SETUP:
SER-COM,UART2
SETUP:
SER-COM,UART3
Intermec EasyCoder 501 XP – Service Manual Ed. 4
SER-COM,UART2:
BAUDRATE
SER-COM,UART2:
PROT ADDR
SER-COM,UART2:
CHAR LENGTH
SER-COM,UART2:
PARITY
SER-COM,UART2:
STOP BITS
SER-COM,UART2:
FLOWCONTROL
SER-COM,UART2:
NEW LINE
SER-COM,UART2:
REC BUF
SER-COM,UART2:
TRANS BUF
SER-COM,UART2:
CONNECTED HW
SER-COM,UART2:
PROTOCOL ADDR.
BAUDRATE:
9600
19200
38400
57600
300
600
1200
2400
4800
These menus are only displayed if RS 485 is selected on "uart2:"
PROT ADDR:
DISABLE
ENABLE
These menus are not displayed if RS 485 is selected on "uart2:"
CHAR LENGTH:
8
7
PARITY:
NONE
EVEN
ODD
MARK
SPACE
STOPBITS:
1
2
FLOWCONTROL:
RTS/CTS
FLOWCONTROL:
ENQ/ACK
FLOWCONTROL:
XON/XOFF
NEW LINE:
CR/LF
LF
CR
REC BUF:
[300]:
TRANS BUF:
The selected type of hardware connection on "uart2:"
[300]:
is displayed as one of the following alternatives (read-only):
• RS232
CONNECTED HW:
• 422 NON ISOLATED
RS232
• 422 ISOLATED
• RS485
PROTOCOL ADDR.
These menus are only displayed if RS 485 is selected on "uart2:"
Enter printer's protocol address (0–31).
[1]:
Appendix 1 Program Overviews
RTS/CTS flowcontrol cannot be
RTS/CTS:
selected for the following types of
DISABLE
hardware connection on "uart2:":
ENABLE
• 422 NON ISOLATED
• 422 ISOLATED
ENQ/ACK:
DISABLE
ENABLE
XON/XOFF:
DATA TO HOST
XON/XOFF:
DATA FROM HOST
DATA TO HOST:
DISABLE
ENABLE
DATA FROM HOST:
DISABLE
ENABLE
167