Right-Hand Door - Intermec EasyCoder 501 XP Service Manual

3. Hatches and Doors

3.1 Right-Hand Door

Intermec EasyCoder 501 XP – Service Manual Ed. 4
The right-hand door gives access to:
• The media supply
• The ribbon supply
• The print mechanism
The right-hand door is fi tted to the bottom plate by means of two
hinges that allow the door to be swung down 180˚ to a vertical
position. The door is kept shut by means of a magnetic lock. The
door can easily be removed from the hinges by pushing it forward
until the snap-lock at the rear hinge becomes disengaged.
At the inside of the door, there is a label showing how to load the
media and transfer ribbon.
Hinges
The hinges can be adjusted by means of the two pairs of #T10
Torx screws visible on the outside. Possibly, the other parts of the
hinges, which are fi tted to the bottom plate, may require adjust-
ment too. Shut the door, loosen the screws slightly and align the
door with the front moulding. Tighten the screws and check that
the door runs freely and is kept shut by the magnetic lock.
Chapter 3
Magnetic Lock
Label
19