3-Inch Adapter; Label Taken Sensor; Real Time Clock; Compactflash Protection Plate - Intermec EasyCoder PX4i User Manual

3-inch Adapter

Label Taken Sensor

Real Time Clock

CompactFlash Protection Plate

EasyCoder PX4i Bar Code Label Printer User's Guide (Fingerprint Version)
The 3 in/76 mm adapter is included in the package and makes it
possible to use media rolls with 3 in/76 mm inner diameter
cardboard cores.
The adapter is pressed onto the media supply hub and held in
place by a screw. When fitting the adapters, make sure that the
screw hits a rounded plastic surface, not a metal leaf spring.
Illustrations of how to load the media using the adapter can be
found in "Loading Media" on page
The Label Taken Sensor (LTS) is a photoelectric sensor fitted to
the center section inside the front door. It allows the printer's
firmware to detect if the latest printed label, ticket, tag etc. has
been removed before printing another copy.
The label taken sensor is usually factory-fitted, but is also
available as a kit for installation by an authorized service
technician. It cannot be fitted in combination with a paper
cutter.
The LTS can be enabled or disabled by means of the instructions
LTS& ON and LTS& OFF respectively in Intermec Fingerprint
and the Intermec Direct Protocol.
This factory or field-installed circuit (RTC) relieves the operator
or the host from having to set the clock/calendar using the
Intermec Fingerprint instructions DATE$ and TIME$ after each
power up. The RTC has its own backup battery backup that will
last 10 years or more.
The protection plate encloses an inserted CompactFlash card and
makes it more difficult to steal, see illustration in
Card" on page 18. Operator-installed.
Chapter 9 — Options
23.
"Memory
105