Media Guide, Bottom Assy - Intermec pm43 Service Manual

TITLE
PM43 Service Work Instructions

Media Guide, Bottom Assy

OPERATION:
The bottom media assembly include the media guide sensor for printing on different media (label) width. This assembly is used
on both the PM43 and PM43c.
The assembly is secured by the bottom base print mechanism and it secure by the guide posts (2 each side of the bottom
guide) against the spine (main deck) and the inside of the bottom base print mechanism.
Tools Required
Description
None required
Parts Required
Item Part Number
1 710-120S-001
2 808-002-000
Bottom Dancer Media Guide Assembly Replacement
1. Remove bottom base print mechanism assembly. See Page 14&15 on how to remove the bottom base print mechanism
assembly.
2. Disconnect the media guide sensor cable P34 from main logic board (MLB) and cut the tie cable securing the cable.
3. Detach the bottom media guide assembly from the spine (main deck). It is
See Figure 1 & Figure 2.
4. Reverse the procedure for installing replacement bottom media guide assembly.
Figure 1
Description
Guide, Media, Bottom Dancer, Assy Spare PM43 (complete assembly include media guide
sensor, belt, adjust lever, etc.)
Cable, Tie, White, Locking, 4inch
Guide, Media, Bottom Dancer Assembly Spare
Intermec Proprietary Document
Model DOCUMENT NO.
PM43,PM43C SWIPM43x-000
Part Number
IMPORTANT to make note of the guide posts.
Figure2
1
PAGE
Page
25 of 70
Qty
1
1