Intermec EasyCoder 501 XP Service Manual page 55

Chapter 8 Print Unit
8.6 Label Stop Sensor,
cont.
Upper Sensor
Lower Sensor
54
Replacing the Sensors
To remove the LSS bracket from the carriage, for example in con-
nection with cleaning or replacing a sensor, proceed as follows:
• Switch off the power, remove the power cord and remove the
cover over the electronics compartment.
• Remove the upper and lower plastic guide plates.
• Adjust the LSS to approximately center position.
• Disconnect the cables from P53 and P54 on the CPU board.
• Disengage the snap-lock, using a screwdriver from the media
compartment side, and push the outer end of the LSS bracket
upward. Then pull the bracket out from the carriage, taking care
not to damage the cables.
Note! The snap-lock is fragile.
• Remove the two #T8 Torx screws that hold the defective sensor
and replace it.
Snap-Lock
Carriage
Intermec EasyCoder 501 XP – Service Manual Ed. 4
LSS Bracket