Intermec Shell 4.4 Overview - Intermec EasyCoder 501 XP Service Manual

Appendix 1

Intermec Shell 4.4 Overview

ENTER=SHELL
POWER ON
5 sec. v.4.4
ENTER=SHELL
4 sec. v.4.4
ENTER=SHELL
3 sec. v.4.4
ENTER=SHELL
2 sec. v.4.4
ENTER=SHELL
1 sec. v.4.4
Last selected
application is started
Default:
Fingerprint 7.40
w. std I/O = "uart1:"
Legend:
Return to previous menu.
Proceed to next menu.
Accept displayed option
and proceed, or
execute displayed option.
Perform a Testfeed
anywhere in Intermec Shell.
Enter the Setup Mode
from anywhere
in Intermec Shell.
Enter Terminal Setup
by transmitting T T T
or t t t to printer,
when menus marked with a
shade of grey are displayed!
Note!
To enter Intermec Shell if a custom-made autoexec-fi le prevents access, lift the printhead and press any
key on the printer's keyboard (except the <Shift> key), then switch on the power while continuing to
press the key. When the Shell countdown begins, release the key and press <Enter> to start Shell. Do
not forget to lower the printhead if you want to print for example test labels.
164
SHELL
SEL. APPLICATION
SEL. APPLICATION
CURRENT APPL.
SEL. APPLICATION
LABELSHOP
SEL. APPLICATION
WINDOWS DRIVER
SEL. APPLICATION
Fingerprint 7.40
SEL. APPLICATION
Direct Protocol
SEL.APPL rom:
LINE_AXP.PRG
SHELL SETUP:
SETUP SER-COM,UART1
SHELL
PRINT SETUP
SHELL
TESTFEED
SHELL
TEST LABEL
SHELL
ARE YOU SURE ?
DEFAULT SETUP
Y=ENTER/ N=F5
UPDATE:
SHELL
PC-CARD?
SOFTWARE UPDATE
UPDATE:
FIRMWARE
SHELL
Restarts the printer (same as power off/on)
REBOOT
See "Setup Mode"
Prints a list of current setup values (test label #5).
Performs a Testfeed, i.e. feeds out a number of blank copies
while autoadjusting the label stop sensor.
Prints test labels #1 – #4 in a loop.
Press Enter for each new label.
DEFAULT SETUP
PERFORMED
PC-CARD ERASE
TRANSFER FILE
USING ZMODEM
TRANSFER FILE
USING ZMODEM
Intermec EasyCoder 501 XP – Service Manual Ed. 4
Last selected application is started
The Windows driver option requires an
optional Centronics interface pcb.
STD I/O CHANNEL
UART1
STD I/O CHANNEL
UART2
See note 1
STD I/O CHANNEL
UART3
See note 1
STD I/O CHANNEL
CENTRONICS
See note 1
STD I/O CHANNEL
net1:
See note 1
Note 1: Dotted options are only shown if
an appropriate optional interface pcb is fitted.
PROGRAMMING
PC-CARD
PROGRAMMING
COMPLETED
Printer rebooted
automatically