Tv Channel Operation - Icom IC-92A Instruction Manual

5
BASIC OPERATION

■ TV channel operation

TV channel operation is available only when TV channels
are programmed using the optional RS-91.
available for A band operation only.
D TV channel receiving
q Push [CALL] several times to select TV channels.
• " TV" and channel number appear.
w Rotate [DIAL] to select the desired channel.
• While pushing and holding [BAND], rotating [DIAL] selects the
all channels including skip channel.
CALL
RX CS
D Skip channel setting
Unwanted channels can be skipped for rapid selection, etc.
q Push [CALL] several times to select TV channels.
• "TV" and channel number appear.
28
(p. 122)
TV mode indication
Channel indication
+DUP +DUP DTCS DTCS
WFM PRIO WX PRIO WX EMR EMR
10
CH CH
25 25
A
MemoName MemoName
P SKIP
TV TV
μ
C
LOW LOW
ATT ATT
w Rotate [DIAL] to select the channel to be skipped.
• To clear the skip setting, rotate [DIAL] while pushing and hold-
Also
ing [BAND] to select a skip channel.
e Push and hold [SKIP](5) for 1 sec. to toggle the skip set-
ting ON and OFF.
• "SKIP" appears when the channel is set as skip channel.
D
BAND
5
SKIP
D Automatic TV channel programming
TV channels can be programmed automatically.
q Push [CALL] several times
to select TV channels.
• " TV" and channel number ap-
pear.
w Push [SCAN](2) to start TV
channel programming.
• The programming will automatically stop after scanning all
channels.
Appears
+D U P +DUP DTCS D TCS
WFM WFM
PRIO PRI O W X EMR WX EM R
12 ch
A
25 25
M em oN am e Mem oName
SKIP
P
TV TV
µ
LOW L O W
C
AT T ATT
CALL
RX CS
+DUP +D U P D TCS DTCS
WFM WFM
PRI O PRIO WX W X EMR
2 ch
A
Mem oName M em oN am e
P
µ
LOW L O W
AT T ATT
EM R
25 25
SKIP
TV TV