Resetting; All Reset; D Partial Reset - Icom IC-92A Instruction Manual

12
OTHER FUNCTIONS

■ Resetting

The function display may occasionally
display erroneous information (e.g.
when first applying power). This may
be caused externally by static electric-
ity or by other factors.
If this problem occurs, turn power OFF.
After waiting a few seconds, turn power
ON again. If the problem persists, per-
form either or both procedures below.

• All reset

Reset the CPU before operating the
transceiver for the first time, or if the
internal CPU malfunctions, to clear and
return all programmed contents to their
default settings.
• Partial reset
If you want to initialize the operat-
ing conditions (VFO frequency, VFO
settings, set mode contents) without
clearing the memory contents, a partial
reset function is available for the trans-
ceiver.
132
D All reset
q Push and hold [PWR] for 1 sec. to
turn power OFF.
w While pushing and holding [VFO],
[MR] and [BAND], then turn power
ON to reset the CPU.
• "ALL RESET" appears when resetting
the CPU (See the illustration below).
ALL RESET ALL RESET
+DUP DTCS
FM PRIO WX EMR EMR
146 010
25 25
A
B
CAUTION:
Resetting the CPU
returns all programmed contents to
their default settings.

D Partial reset

q Push and hold [PWR] for 1 sec. to
turn power OFF.
w While pushing and holding [VFO],
then turn power ON to partially reset
the transceiver.
[NOTE]: No message appears on the
display after the partial reset is done.
PWR
A
VFO
D
MHz
BAND
B
MR
S.MW
ALL RESET
+DUP DTCS
FM PRIO WX EMR
146 010
25
A
B