Icom IC-92A Instruction Manual page 41

y Push [ ](6) to select 2nd digit, then rotate [DIAL]
lect the desired character or code.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
• 2nd digit blinks (1st digit stops blinking).
MY CALL SIGN MY CALL SIGN
M01
r
M†
/
:SET :SET
:SEL :SEL
:CUR :CUR
u Repeat the steps t and y to enter your own call sign.
• Up to a 8-digit of call sign can be set.
• If an un-necessary character is entered, push [ ](6) or [ ](4)
to select the character, then push [CLR](1) to erase the se-
lected character, or push and hold [CLR](1) for 1 sec. to erase
all characters following the cursor.
• When programming a note (Up to a 4-digit for operating radio
type or area, etc.), go to step i, otherwise go to step !0 .
i Push [ ](6) several times to set the cursor beside "/" indi-
cation.
o Repeat steps t to y to program the desired 4-character
note.
MY CALL SIGN MY CALL SIGN
M01
r
MYCALL
/IC91
:SET
:BACK :BACK
DV MODE OPERATION (Optional UT-121 is required for IC-92A)
†
to se-
AB
CLR:CLR CLR:CLR
A/a:CHAR A/a:CHAR
:SEL :SEL
:EDIT :EDIT
CLR:CLR CLR:CLR
!0 Push [ ](5) to store the programmed call sign with note
and returns to MY CALL SIGN screen.
!1 Push [MENU/
] to return to frequency indication.
[DIAL] ↔ [ ](2)/[ ](8)
†
7
](5) ↔ [ ](6)
[
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
35