Removing Volume Information From A Remote Physical Disk; Creating A Link Aggregation Device; Listing Link Aggregation Devices - IBM TotalStorage NAS Gateway 500 Administrator's Manual

CLI command
At the command prompt, enter chpvol -C hdiskname.
SMIT fastpath
The SMIT fastpath is smit chpvol.
WebSM
In WebSM, do the following: NAS Management→NAS System→ Node (Server IP
Address) →Devices→Disks→(right-click a disk)→Properties.

Removing volume information from a remote physical disk

If a volume has been exported from a system, you can format the disk that contains
the volume so that the volume cannot be imported onto a system.
Attention: Data is lost with the use of this command.
CLI command
At the command prompt, enter chpvol -C hdiskname.
SMIT fastpath
The SMIT fastpath is smit chpvol.
WebSM
In WebSM, do the following: NAS Management→NAS System→ Node (Server IP
Address) →Devices→Disks→(right-click a disk).

Creating a link aggregation device

You can create a link aggregation device.
CLI command
At the command prompt, enter mklinkagg -e adapterlist.
SMIT fastpath
The SMIT fastpath to create a link aggregation device is smit mklinkagg.
WebSM
To create a link aggregation device in WebSM, go to: NAS Management→NAS
System→ Node (Server IP Address) →Devices→Communication→Overview and
TasksCreate a link aggregation.

Listing link aggregation devices

You can list configured link aggregation devices.
CLI command
At the command prompt, enter lslinkagg.
SMIT fastpath
The SMIT fastpath to list a link aggregation device is smit lslinkagg.
WebSM
To list a link aggregation device in WebSM, do the following: NAS
Management→NAS System→ Node (Server IP Address)
→Devices→Communication→All Link Aggregations.
Chapter 24. Managing devices
123