Table of Contents
Advertisement
Clustered systems
Remote mirrored systems
22
NAS Gateway 500 Administrator's Guide
2. General Setup Wizard (sets the date, time, root password, and so on)
3. Network Configuration Wizard (optionally runs the Link Aggregation
Wizard and then configures the Ethernet ports)
4. Static Routes Wizard
5. CIFS Wizard (if CIFS was selected in the Feature Selection Wizard)
6. Volume Wizard (configures NAS volumes, sharing and snapshots)
Note: In clustered systems, the WebSM client workstation used for
configuration attaches to a single node of the cluster that is
designated as the primary node. The Initial Configuration Wizard is
run on the primary node only, and the second node is configured
automatically.
The wizards run in the following order:
1. Feature Selection Wizard (allows selection of CIFS File Serving and
Clustering)
2. General Setup Wizard (sets the date, time, root password, and so on)
3. Cluster Wizard (optionally runs the Link Aggregation Wizard and
configures IP addresses)
4. Static Routes Wizard
5. CIFS Wizard (if CIFS was selected in the Feature Selection Wizard)
6. Volume Wizard (configures NAS volumes, sharing and snapshots)
Note: When Remote Mirroring is used, before you perform full initial
configuration, you must do some limited configuration at the remote
site. This allows network communication between the sites. First,
start initial configuration at the remote site. Then, when the Remote
Mirroring Wizard is reached, perform step 1 (see Chapter 7, "Using
the Remote Mirroring Wizard," on page 27) and initial configuration
exits. After this remote site network configuration is completed, start
initial configuration at the local site and select step 2 (see Chapter 7,
"Using the Remote Mirroring Wizard," on page 27) at the Remote
Mirroring Wizard. All remaining configuration is performed from the
local site and propagated to all other nodes (local and remote).
The wizards run in the following order:
1. Remote node — Feature Selection Wizard (allows for the selection of
Remote Mirroring)
2. Remote node — Remote Mirroring Wizard (perform Step 1)
3. Local node — Feature Selection Wizard (allows selection of CIFS File
Serving, Clustering, and Remote Mirroring)
4. Local node — Remote Mirroring Wizard (perform Step 2)
5. Local node — General Setup Wizard (sets the date, time, root
password, and so on)
6. Local node — Cluster Wizard (optionally runs the Link Aggregation
Wizard and configures IP addresses)
7. Local node — Static Routes Wizard
8. Local node — CIFS Wizard (if CIFS was selected in the Feature
Selection Wizard)
Advertisement
Table of Contents
