Table of Contents
Advertisement
10. Click Next to continue to the Remote Site Mirroring Network panel.
Figure 8. Remote Site Mirroring Network for two nodes
11. Enter the appropriate information for the Remote Site Mirroring Site just as you
12. You can add additional GeoNetworks by clicking More Mirroring Networks,
13. When you are finished adding mirroring networks, click Next to continue to the
shuts itself down. In the case of two nodes at one site and one node at the
other, dominance does not apply; the site with the least number of nodes takes
itself down.
8. Enter the information for the first node:
a. Node 1 Host Name.
The host name can be from one to 31 alphanumeric or underscore
characters only; although you cannot begin the host name with a number.
The names must be unique; if the names are longer than 24 characters, at
least one of the first 24 characters must be unique.
b. Select the proper Adapter Card slot and port number.
c. Enter the IP address for this port.
9. If your site has two nodes, then enter the appropriate information for the
second node.
The number of fields in the Remote Site Mirroring Network panel will depend
on the number of nodes at this site. Figure 8 is for a site with two nodes; if
your site has only a single node, then the fields for the second node will not
appear.
just did for the Local Site. If you need to configure any ports for link
aggregation, you can select the Configure Link Aggregation button.
which repeats these same network screens for subsequent networks. One
GeoNetwork is required, and at least two GeoNetworks are highly
recommended.
General Setup wizard.
Chapter 7. Using the Remote Mirroring Wizard
31
Advertisement
Table of Contents
