Table of Contents
Advertisement
SMIT fastpath
The SMIT menu fastpath command to set up CIFS is smit cifs. Then select CIFS
Configurationand then select Basic Setup.
CIFS authentication
To perform CIFS authentication, use the SMIT fastpath smit cifs.
SMIT fastpath
The SMIT menu fastpath command to perform CIFS authentication is smit cifs.
1. Select CIFS Configuration and Authentication.
2. Then select one of the following:
Authentication (General)
Sets the following general CIFS parameters:
Use Encrypted Passwords
Prevents client passwords from being accepted in encrypted
form in the session set up with the server.
Client user name mapping
Specifies if the User Name Mapping feature is enabled.
Enable Guest-mode logon
Specifies whether or not guest access is allowed.
Guest logon ID
Specifies the logon name to be used as guest on the server.
Enable share level security
Specifies if share level security should be enabled instead of
user level security.
Share level security user login
Specifies the user name to be used for file access credentials
when share level security is enabled.
Remote Authentication options
Sets the following CIFS parameters:
CIFS Passthrough authentication server
Specifies the IP address of the passthrough authentication
server.
CIFS Backup authentication server
Specifies the IP address of the backup passthrough
authentication server.
Kerberos-based authentication
Specifies whether Kerberos based authentication should be
used. If you enable Kerberos based authentication, then you
must also specify the Kerberos service name. The Kerberos
service name specifies the service name of the Kerberos
domain controller to which the CIFS server authenticates
Kerberos users when the Kerberos based authentication feature
is enabled.
LDAP settings
Defines the following LDAP settings:
v LDAP-based authentication
v LDAP server name
Chapter 25. Managing file serving
141
Advertisement
Table of Contents
