IBM TotalStorage NAS Gateway 500 Administrator's Manual page 70

Figure 21. Network configuration 1
48
NAS Gateway 500 Administrator's Guide
If no Ethernet adapters appear, then click Next without entering any
configuration parameters. On this panel:
a. The primary and secondary DNS addresses are used to resolve host names
into dotted IP addresses. Enter the DNS address.
b. Enter the default gateway.
c. Under the configure Ethernet adapters section, you see a list of adapter
ports that have not yet been configured. Select the adapter port you want to
configure and click Edit. You can configure any or all of the adapter ports in
the list.
Note: The adapter ports are not part of the cluster. They do not provide fail
over, and cannot do cluster file serving. After selecting an adapter
port and clicking Edit, the configure Ethernet adapters panel appears
allowing you to select a static or dynamic address for the specified
adapter port.
1) If you select static, you can enter the IP address and subnet mask for
the specified adapter port.
2) Click OK to complete the change and return to the network configuration
panel.
d. Click Next to display the next Network configuration panel.