Table of Contents
Advertisement
Chapter 2. NAS administrator's installation checklist
Table 2. NAS administrator's installation checklist
Task
Confirm that worksheets are completed.
h Cable Planning Chart
h Adapter configuration worksheet
h Remote mirroring worksheets
h Clustering worksheets
h CIFS worksheet
h User mapping worksheet
h Volume worksheet
h Electronic Service Agent worksheet
Verify that your SAN storage is pre-configured. See the Attention notice at the beginning of
h
Verify that the WebSM Client workstation
h
meets minimum requirements and that it is
connected to the network.
Confirm that all cables are connected. If
h
clustering, verify that the cables in Feature
1001 are connected.
Power on the NAS Gateway 500.
h
Enter the IP address that is displayed on the
h
display panel on the front of the NAS Gateway
500 into a Web browser that is executing on
the managing console.
Accept the software license agreement.
h
Install the Web-based System Manager
h
Remote Client, if required.
Install Subsystem Device Driver (SDD), if
h
required.
Log in to NAS Gateway 500.
h User ID (root)
h Password (password)
Select optional features.
h
If Remote Mirroring:
1. h Initialize the remote node.
2. h Configure Remote Mirroring from local
site 25.
Set date and time.
h
Define root user and set password.
h
Create NAS Gateway 500 administrators and
h
set passwords.
Create file access users
h
Select Directory Services.
h
© Copyright IBM Corp. 2004
Reference
Using the initial setup wizards
A copy of these worksheets can be found in the
Appendixes of the IBM TotalStorage NAS Gateway
500 Planning Guide, GA27-4335.
Chapter 13, "Using the Volume Wizard," on page 59.
See "Installing the Web-based System Manager
Remote Client" on page 15.
Refer to IBM TotalStorage NAS Gateway 500
Hardware Installation Guide, GA27-4336.
The power-on button is the white button at the top left
of the display panel. Refer to IBM TotalStorage NAS
Gateway 500 Hardware Installation Guide,
GA27-4336.
See Chapter 3, "Getting started," on page 13.
See "Accepting the license agreement" on page 14.
See "Installing the Web-based System Manager
Remote Client" on page 15.
SDD is not preinstalled on the NAS Gateway 500. It
can be used for clustered or nonclustered systems.
Refer to your storage documentation.
See Figure 2 on page 20.
See Figure 3 on page 25.
1. See "Step 1 (from the remote site)" on page 28.
2. See Chapter 7, "Using the Remote Mirroring
Wizard," on page 27.
See item 1 on page 33
See item 2 on page 34.
See item 3 on page 35.
See item 5 on page 38.
See item 4 on page 36.
9
Advertisement
Table of Contents
