Fujitsu ETERNUS DX60 S3 Configuration Manual page 31

Chapter 2 Rack Installation
2.2 Controller Enclosure Installation (for Regions Other than EMEA&I)
Make sure to attach the rack rails to rack pillars so that they fit exactly together without any space
between them.
Plate
M5 screw
(Rack pillar: front)
The M5 screw positions for the rack rails are determined by the controller enclosure base line.
Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in the
2nd and 5th holes on the rear rack pillars above the base line to fasten the rack rails.
6th hole
(M5 screw)
1st hole
(M5 screw)
5th hole
(M5 screw)
2nd hole
(M5 screw)
3
Tighten the M4 screws of the rack rails that were slightly unscrewed in
Rack rail (left)
Plate
M5 screw
Controller enclosure: front
[Left]
2U
Controller
enclosure base line
Rack rail
Controller enclosure: rear
[Left]
2U
Controller
enclosure base line
Rack rail
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
M5 screw
Washer
(Rack pillar: rear)
Rack rail (right)
[Right]
6th hole
(M5 screw)
1st hole
(M5 screw)
[Right]
5th hole
(M5 screw)
2nd hole
(M5 screw)
31
M5 screw
Washer
Step 1.
P3AM-9002-01ENZ0