Fujitsu ETERNUS DX60 S3 Configuration Manual page 110

Chapter 8 SAN Connection Settings
8.1 Connection Settings for the ETERNUS DX
8.1.2.3 CA Port Group Creation
Create a CA port group for a host to access the ETERNUS DX.
A CA port group is a group of host interface ports that have the same interface and connect to the specific
host group.
The procedure to create a CA port group is as follows:
1
Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen. On the [Connectivity]
screen, click [Port Group] in [Category].
The [CA Port Group] screen appears.
2
In [Action], click [Create iSCSI Port Group].
The [Create iSCSI Port Group] screen appears.
3
In the [Create iSCSI Port Group] screen, enter the name of the CA port group that is to be created, select
the checkbox for the ports that are to be registered in the CA port group, and click the [Create] button.
A confirmation screen appears.
4
Click the [OK] button.
The CA port group is created and the setting completion screen appears.
5
Click the [Done] button.
The screen display returns to the [CA Port Group] screen.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
110
P3AM-9002-01ENZ0