Fujitsu ETERNUS DX60 S3 Configuration Manual page 120

Chapter 8 SAN Connection Settings
8.2 Server Connection Setup
12
Confirm that the ETERNUS DX iSCSI name is displayed in [Discovered targets] and that the [Status] is
[Inactive].
13
Select the iSCSI name that is to be the connection target, and click the [Connect] button.
In this example, "CM#0 CA#0 Port#0" with an iSCSI name that is specified in
ter Settings" (page 108)
[Connect To Target] appears.
14
Confirm the controller number at the end of the target name and click the [Advanced] button.
15
On the [Advanced Settings] screen, specify the following items under [Connect using] and click the
[OK] button.
Local adapter: Microsoft iSCSI Initiator
Initiator IP: IP address of the server (A in
is the target.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Figure 8.1)
120
"8.1.2.2 iSCSI Port Parame-
P3AM-9002-01ENZ0