Copy Table Size Settings - Fujitsu ETERNUS DX60 S3 Configuration Manual

Chapter 9 Advanced Copy Settings
9.1 Advanced Copy Basic Settings
Select this mode when performance is affected (such as when the performance of host response is
reduced) by the Automatic Priority or Low Priority mode.
4
In the confirmation screen, click the [OK] button.
EC/OPC priority setting starts.
5
In the setting completion screen, click the [Done] button.
The screen display returns to the [Setting (Advanced Copy)] screen.
9.1.2

Copy Table Size Settings

On the controller cache memory, set the copy table size used by the firmware.
This copy table is used as the area for copy progress management when the EC or OPC (OPC, QuickOPC, Sna-
pOPC+) functions are executed.
When the copy table size is 0MB, the copy function cannot be used.
•
• Before reducing the copy table size, stop copy sessions.
The maximum capacity of copy table size is 128MB.
•
Changes in the resolution is applied when the next copy session starts. If a copy session is already run-
•
ning, copy is continued with the resolution set at the beginning of the copy session. To apply the
changed resolution to a running copy session, cancel the target copy session and then start the session
again.
It is recommended to set the maximum resolution if the amount of data increase in the copy target area
•
cannot be estimated.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
138
P3AM-9002-01ENZ0