Chapter 5 General Settings - Fujitsu ETERNUS DX60 S3 Configuration Manual

Chapter 5
General Settings
This chapter explains how to set up the ETERNUS DX.
■
Initial Settings After Installation
The following settings must be performed when an ETERNUS DX is installed.
●
Storage Management
Perform the device information settings and the network connection settings All of the required settings can
be performed by following the instructions that are displayed when the Initial Setup 1 wizard is used.
●
Firewall Settings
Select whether to enable or disable connections for each service that is to be used via the LAN for operation
management.
●
RAID Configuration Settings
Register the RAID groups, the volumes, and the hot spares in the ETERNUS DX.
●
Monitoring Settings
Perform the settings to enable constant monitoring of the storage system status. For details on these set-
tings, refer to
●
Power Control Setup
Perform the storage system power control settings. For details on these settings, refer to
Control Setup" (page
●
SAN Connection Settings
Perform the settings for SAN connections with the server. For details on these settings, refer to
8 SAN Connection Settings" (page
●
Advanced Copy Settings
Perform the basic settings to use the Advanced Copy function. For details on these settings and performing
SnapOPC+, refer to
"Chapter 6 Monitoring Settings" (page
101).
105).
"Chapter 9 Advanced Copy Settings" (page
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
81).
137).
55
"Chapter 7 Power
"Chapter
P3AM-9002-01ENZ0