Eternus Web Gui Startup - Fujitsu ETERNUS DX60 S3 Configuration Manual

Chapter 5 General Settings
5.3

ETERNUS Web GUI Startup

2
After approximately three minutes, check that the READY LED ( ) is lit up.
When checking the connection between the PC terminal and the ETERNUS DX, execute the "ping" com-
mand at the PC command prompt. An example of ping execution is shown below. ("192.168.1.1" is the
default IP address for the ETERNUS DX)
ping 192.168.1.1
If the execution results in an error, check the network settings of the PC terminal.
When communication cannot be established even after the RMT port of Controller 0 (CM#0) is con-
nected to the LAN port of the PC terminal, make sure that the MASTER LED of Controller 0 (CM#0) is
turned on. When two controllers are installed and the MASTER LED of Controller 1 (CM#1) is turned
on, use the RMT port of Controller 1 (CM#1).
5.3 ETERNUS Web GUI Startup
Start up ETERNUS Web GUI via the Web browser of the connected terminal.
If the settings of the Web browser are incorrect, ETERNUS Web GUI may not be connected. For details on
these settings, refer to "Configuration Guide (Web GUI)".
1
Open the Web browser on the terminal.
2
Enter the following URL in the address bar of the Web browser:
http://192.168.1.1/
The login screen for ETERNUS Web GUI appears.
3
To change the language, click the [Option] button and select [English] or [Japanese] in [Language:].
4
Enter the User ID and Password.
User ID: root
Password: root (by default)
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
61
P3AM-9002-01ENZ0