Table of Contents
Advertisement
Figure 5-16: Connect the LPT Device
5.7.7 Dual RS-232 Cable with Slot Bracket
The dual RS-232 cable slot connector consists of two connectors attached to two
independent cables. Each cable is then attached to a D-sub 9 male connector that is
mounted onto a slot. To install the dual RS-232 cable, please follow the steps below.
Step 1:
Locate the connectors. The locations of the RS-232 connectors are shown in
Chapter 3.
Step 2:
Insert the cable connectors. Insert one connector into each serial port box
headers. See
the connector can only be installed in one direction.
Page 84
PICOe-945GSE Half-Size CPU Card
F igure 5-17. A key on the front of the cable connectors ensures
8 2 2 H
Advertisement
Chapters
Table of Contents
