Table 5-1: Jumpers; T Able 5-2: At Power Select Jumper Settings - IEI Technology PICOe-945GSE User Manual

PICOe-945GSE Half-Size CPU Card
Description
AT Power Mode Setting
CF Card Setting
Clear CMOS
LVDS Panel Resolution
LVDS Voltage Select
PCIe Status Select

Table 5-1: Jumpers

5.5.1 AT Power Select Jumper Settings
NOTE:
The AT Power Select Jumper is the same as the ATX Enable
connector.
Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
The AT Power Select jumper specifies the systems power mode as AT or ATX. Use a
jumper cap to short pin 1 - pin 2 on the ATXCTL1 connector to enable the AT Power mode
on the system. In the ATX mode use the PS_ON- and 5VSB cable. AT Power Select
jumper settings are shown in
Label Type
ATXCTL1 2-pin header
JCF1 2-pin header
J_CMOS1 3-pin header
J_LCD_TYPE1 8-pin header
J_VLVDS1 3-pin header
J_PCIE1 2-pin header
ATXCTl1
3-pin wafer
See T able 5-2
7 8 8 H
See F igure 5-4
7 8 9 H
T able 5-2.
7 9 0 H
Page 67