Figure 5-2: Cf Card Installation; Figure 5-3: Jumper Locations; Jumper Settings - IEI Technology PICOe-945GSE User Manual

Figure 5-2: CF Card Installation

5.5 Jumper Settings

NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
Before the PICOe-945GSE is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the PICOe-945GSE are listed
in T able 5-1.
8 2 9 H 7 8 7 H
Page 66
PICOe-945GSE Half-Size CPU Card

Figure 5-3: Jumper Locations