Instructions For Insertion - Removing Of Hmi-Cfw08-P; Tcl-Cfw08; Hmi-Cfw08-Rp - WEG CFW08 Vector inverter User Manual

8.1.1 Instruction for Insertion
and Removing of the
HMI-CFW08-P
1. Place the keypad as shown above.
2. Press it.
(a) Insertion

8.2 TCL-CFW08

8.3 HMI-CFW08-RP

1. Unlock the keypad by using a screwdriver as shown above.
Figure 8.2 - Instructions for HMI-CFW-08-P insertion and removing
Dummy panel to be inserted in the place of the parallel keypad (HMI-
CFW08-P).
Figure 8.3 - Dimensions of the dummy panel TCL-CFW08 for the parallel HMI
External parallel keypad: this keypad is mounted externally to the
inverter and can be used in the following cases:
Applications that require a remote keypad (up to 10m / 394in);
Instalation of a keypad directly on the panel door (0,12in);
For a better visualization on the display and to facilitale the key
operation, when compared with the parallel keypad (HMI-CFW08-P).
The external parallel keypad (HMI-CFW08-RP) must be used with the
MIP-CFW08-RP interface and CAB-RP-X cable.
CFW-08 OPTIONS AND ACCESSORIES
2. Remove the keypad by pulling on the lateral sides.
(b) Removing
43
13
117