Keypad Copy Function; Mis-Cfw08-Rs; Cab-Rs-10 - WEG CFW08 Vector inverter User Manual

8.6.3 Keypad Copy Function

8.7 MIS-CFW08-RS

8.8 CAB-RS-1
CAB-RS-2
CAB-RS-3
CAB-RS-5
CAB-RS-7.5

CAB-RS-10

CFW-08 OPTIONS AND ACCESSORIES
Function via HMI-CFW08-RS
Frequency reference
Commands (*)
Forward/Reverse Selection
Loca/Remote
Selection
Note:
Factory setting
(*) Except the forward/reverse selection that also depends on the paremater P231.
Table 8.2 - Parameter setting for HMI-CFW08-RS operation
The HMI-CFW08-RS keypad still has an additional function: the keypad
copy function.This function is useful when one wants to copy the settings
of one inverter (source inverter) to another (target inverter) or one needs to
program several inverters with the same settings.
This is done as follows: the parameters of the source inverter are copied
to a non-volatile memory of the HMI-CFW08-RS keypad , and then from
this keypad to another inverter ("target inverter"). The keypad copy function
is controlled by the paramater P215.
For further information on this function refer to section 6.
Serial interface used exclusively for HMI-CFW08-RS keypad connection
to inverter.
The procedures for insertion and removing of the MIS-CFW08-RS are si-
milar to those shown in Figure 8.13 for the KCS-CFW08 module.
Figure 8.11 - Dimensions of the MIS-CFW08 serial communication module
Cables used to connect the inverter to the external serial interface keypad
(HMI-CFW08-RS). There are 6 cable options ranging in lengths from 1m
to 10 m. The user must select among these lengths according to his
requirement.
The cable CAB-RS must be laid separately from the power wiring by
meeting the requirements for the control wiring (refer to item 3.2.4).
Local Mode
P221 = 0
P229 = 2
P231 = 2
P220 = 5 (default local) or
P220 = 6 (default remote)
21
43
fot the extern serial HMI
Remote Mode
P222 = 0
P230 = 2
20
121