CFW-08 OPTIONS AND ACCESSORIES
8.11 KMD-CFW08-M1
124
To install the RS-232 communication kit on the PC, proceed as follows:
-
Remove the parallel keypad (HMI-CFW08-P) from the inverter.
-
Install the serial communication module RS-232 (KCS-CFW08) in the
place of the keypad.
-
Install the software "SUPERDRIVE" in the PC.
-
Connect the inverter to the PC through the cable.
-
Follow the instruction given by the "SUPERDRIVE".
This device must be used when the installation of the inverter on 35mm
rail, according to DIN EN 50.022, is desired
Only available for the models: 1.6-2.6-4.0-7.0A/ 200-240V and
Section A-A
75
Figure 8.15 - Inverter with DIN rail kit (KMD-CFW-08-M1)
1.0-1.6-2.6-4.0A/380-480V
Front View
B
A
B
64
Section B-
A'