About This Manual; Version Of Software; General Information - WEG CFW08 Vector inverter User Manual

CHAPTER 2

GENERAL INFORMATION

This chapter defines the contents and purposes of this manual and
describes the main characteristics of the CFW-08 frequency inverter.
Identification, receiving inspections and storage requirements are also
provided.
This Manual is divided into 10 Chapter, providing infornation to the user on

2.1 ABOUT THIS MANUAL

how receive, install, start-up and operate the CFW-08:
Chapter 1 - Safety Notices;
Chapter 2 - General Information;
Chapter 3 - Installation;
Chapter 4 - Start-up;
Chapter 5 - Keypad HMI) Operation;
Chapter 6 - Detailed Parameter Description;
Chapter 7 - Diagnostic and Troubleshooting;
Chapter 8 - CFW-08 Options and Accessories;
Chapter 9 - Technical Specifications;
Chapter 10 - Warranty Policy.
This Manual provides information for the correct use of the CFW-08. The
CFW-08 is very flexible and allows for the operation in many different
modes as described in this manual.
As the CFW-08 can be applied in several ways, it is impossible to describe
here all of the application possibilities. WEG does not accept any
responsibility when the CFW-08 is not used according to this Manual.
No part of this Manual may be reproduced in any form, without the written
permission of WEG.
2.2 SOFTWARE VERSION
It is important to note the Software Version installed in the Version CFW-
08, since it defines the functions and the programming parameters of the
inverter.
This Manual refers to the Software version indicated on the inside cover.
For example, the Version 3.0X applies to versions 3.00 to 3.09, where "X"
is a variable that will change due to minor software revisions. The operation
of the CFW-08 with these software revisions are still covered by this version
of the Manual.
The Software Version can be read in the Parameter P023.