V100 Compact Multiplexer; Option Card Installation; Analogue Voice/Fax Card - Vocality V100 Technical Manual

Versatile and compact

Table of Contents

From left to right, the rear panel accommodates the IEC line inlet and fan, followed by the Special Option

bay. Next are the DB9F Supervisor port, the DB9M HSC port and data ports 1 and 2 and finally Option Bay

1 and Option Bay 2. The example above is shown without any option cards fitted.

2.3.2

V100 Compact Multiplexer

The V100 Compact is housed in a 1U tall enclosure with a DC min-plug inlet and separate fuse. The

enclosure comprises four parts incorporating chassis, inner front panel, outer front panel and lid. The lid is

retained by 12off M3 black, anodised, posidrive screws.

The front panel has indicators for PORT1 and PORT2 status (flashing red or green), TEST (red/green) and

OPTION 0 (on RevD units) and OPTION1 data activity (red/green). The meaning of these indicators is

discussed in Section 4.1.

2.4

REMOVE POWER FROM THE UNIT. Option cards are installed from the rear of the unit. First unscrew the

two blanking plate screws and remove the plate. Taking care to align the edges of the Option Card PCB

with the card guides inside the unit, slowly slide in the card until the bezel is approximately 6mm from the

rear panel. One final push will locate the connector internally and the bezel should lie flush with the rear

panel. Replace the two locating screws.

2.4.1

The Analogue Voice/FAX card presents 8-way RJ45 connectors for a maximum of eight

channels. The top four connectors for channels 5 to 8 are only activated when the

expansion Voice/FAX Daughterboard (VI68702) is fitted. The orientation of channel

numbers is as follows:

V100 Versatile Multiplexer Technical Manual Version 2.2

WARNING: STATIC SENSITIVE COMPONENTS!

ESD PRECAUTIONS MUST BE OBSERVED WHEN FITTING

OPTION CARDS REFER TO APPENDIX A

Page 19 of 231

C H A P T E R

I N S T A L L A T I O N

Table of Contents