Table of Contents
Advertisement
C H A P T E R
4
F E A T U R E S
It is also possible to use the return path to the hub at the same time. If we extend the example by
considering the first remote unit to provide the red feed, the second the blue feed and the third the green
feed, then by specifying the destination codes as"BTRttt,rrr" at both ends (where "ttt" specifies a logical
TX code and "rrr" specifies a logical RX code) we can make the return feeds available in a return broadcast
from each unit. To pick out the right channels at each end, "ttt" at one end must match "rrr" at the other
and vice versa. An example of the relevant configuration pages corresponding to this network is given
below, where the hub is shown as Node0, red is Node1, blue is Node2 and green is Node3:
V100 Versatile Multiplexer Technical Manual Version 2.2
Page 152 of 231
Advertisement
Table of Contents
