Replacing The Power Supply; To Replace The Power Supply - Sun Microsystems Ultra 27 Service Manual

Replacing the Power Supply

Close the workstation and prepare for operation using the procedures described in the section,
17
"Closing the Workstation and Preparing for Operation"on page
Replacing the Power Supply
This section describes removing and installing the power supply.
▼

To Replace the Power Supply

Power off the workstation using the procedure described in the section,
1
Workstation"on page
Remove the left-side access panel using the procedure described in the section,
2
Left-Side Access Panel"on page
Unplug the AC power cord from the system.
3
Gently lay the system on its right side on a stable, nonslip surface.
4
The power supply is located in the upper left corner of the interior of the chassis (see
Figure
72 Sun Ultra 27 Workstation Service Manual • June 2009, Revision A
30.
3–26).
31.
34.
"To Power Off the
"To Remove the