Align the screw hole in the I/O board assembly with the captive green retaining screw and
8
tighten the captive screw to secure the I/O board (see
Connect the audio cable (J1), the USB cable (J5), the IEEE 1394 cable (J8), and the I/O cable (J12)
9
from the back side of the I/o board.
Close the workstation and prepare for operation using the procedures described in the section,
10
"Closing the Workstation and Preparing for Operation"on page 34
Replacing the System Cables
▼
To Replace the System Cables
The following system cables have a connector at each end and can be removed or installed by
the customer. All other cables are permanently attached to a system component at one end and
must be removed or replaced along with the component. See or the service label (located on the
left-side access panel) for connector locations.
Chapter 3 • Maintaining the Workstation
Installing the I/O Board Assembly
FIGURE 3–30
Replacing the System Cables
Figure
3–30).
77